#Cisco asav subinterface native vlan software#
Platform Support Through Feature NavigatorĬisco IOS software is packaged in feature sets that support specific platforms. Interface Range Specification, new feature document for Cisco IOS Release 12.1(5)T Supported Platformsįor Cisco IOS Release 12.2(13)T, the following platforms are supported:.Cisco IOS Wide-Area Networking Command Reference, Release 12.2.Cisco IOS Wide-Area Networking Configuration Guide, Release 12.2.You must delete individual subinterfaces to delete a range. The no interface range command is not supported.Wait until the command prompt reappears before exiting interface configuration mode. If you exit interface configuration mode while the commands are being executed, some commands might not be executed on some interfaces in the range. The commands are not batched together for execution after you exit interface configuration mode. Each command you enter while you are in interface configuration mode with the interface range command is executed as it is entered.Individual subinterfaces within a range can be customized or deleted. Overlapping ranges of subinterfaces can be configured. Identical commands can be entered once for a range of subinterfaces, rather than being entered separately for each subinterface.
The VLAN Range feature provides the following benefits: This capability simplifies configurations and reduces command parsing. Using the VLAN Range feature, you can group VLAN subinterfaces together so that any command entered in a group applies to every subinterface within the group. This document includes the following sections: This feature module describes the VLAN Range feature. This command was integrated into Cisco IOS Release 12.2(13)T. The VLAN Range feature was integrated into Cisco IOS Release 12.2(8)T. The interface range command was integrated into Cisco IOS Release 12.2(4)B. The interface range command was expanded to enable configuration of subinterfaces. The interface range command was integrated into Cisco IOS Release 12.1(5)T. The interface range command was introduced.
0 kommentar(er)
